"SOUTHWIRE" ALFLEX THHN BOND WIRE WITH STEEL ARMOR
Constructed with soft-drawn copper, type THHN insulated conductors which are individually wrapped with a moisture-resistant, flame-retardant paper covering. Interlocking steel armor is applied over the assembly. A 16 AWG aluminum bond wire is placed inside the armor, runs longitudinally and is in intimate contact with the armor for its entire length. General applications: Dry locations only, branch, feeder, and service power distribution in commercial, industrial, institutional, and multi-residential buildings, power, lighting, control and signal circuits, concealed or exposed installations, installed in cable tray and approved raceways, environmental air-handling spaces per NEC and under raised floors for information technology equipment conductors and cables per NEC 645.5(D) & 645.5(D)(2). 300.22(C), fished or embedded in plaster. Meets or exceeds the requirements of UL Standard 4 for Armored Cable, UL Standard 83, Federal Specification A-A59544 (formerly J-C-30B), and the National Electrical Code. Listed for use in UL 1, 2, and 3 hour through-penetration firestop systems.
- 15 amps.
- 25' coil.
- Strong protective galvanized steel.
- 600 volts maximum.
- Use only where local electrical codes permit armor/bond wire (armor/bond wire = equipment ground) as the only equipment grounding means.
- 3 hour UL through penetration rated.
- Wires are 90 degree C. rating.
- Dry locations only.
- UL listed.